How to Use a Helium Tank: Setup, Filling Balloons and Safety

Short answer: stand the tank upright and secure it, screw the regulator on hand tight, open the main valve slowly, then press the balloon onto the nozzle and tilt it to fill. Tie the balloon, and close the main valve whenever you take a break. Never inhale helium, and keep the tank out of hot cars and direct sun. Below is how to use a helium tank step by step, including how to open a helium tank, how to fill balloons with a helium tank, and the helium tank safety rules.

How to use a helium tank: filling a latex balloon from the tank regulator

How to Use a Helium Tank Step by Step

  1. Secure the tank. Stand it upright against a wall or a table leg and strap it, or lay it on its side on the floor so it cannot roll. A falling cylinder can break the valve.
  2. Check the valve is closed. Turn the handwheel on top of the tank clockwise until it stops.
  3. Attach the regulator. Screw it onto the valve outlet by hand until it is snug. Do not use a wrench or force it. If you rented from us, the regulator comes with the tank.
  4. Open the main valve slowly. This is how to open a helium tank: turn the handwheel counterclockwise one or two full turns. If the regulator has a gauge, it now shows how full the tank is.
  5. Fill the balloon. Slide the balloon neck over the nozzle, hold it there, and gently push the nozzle sideways. Helium flows while the nozzle is tilted and stops when you let go.
  6. Size the balloon. Fill latex until it is round with a small neck, not pear-shaped and tight. A balloon sizer helps. Fill foil balloons until the seams are smooth but not stretched, and stop when the wrinkles are almost gone.
  7. Tie or seal it. Pinch the neck, slide it off the nozzle and tie it. Most foil balloons seal on their own.
  8. Close the valve when you stop. Turn the handwheel clockwise. Then tilt the nozzle once to let out the helium left in the regulator.
Helium tank secured to the wall with a strap before filling balloons

How Many Balloons Will the Tank Fill?

Before you learn how to fill balloons with a helium tank, make sure the tank is big enough. That depends on the tank and the balloons. A standard 11 inch latex balloon takes about 0.5 cubic feet of helium, so a 60 cubic foot tank fills about 120 of them. Use the helium balloon calculator to add up your balloons and see which tank fits, or read how much helium do I need for the full chart.

How to Fill Balloons With a Helium Tank Faster

  • Set up near the room where the balloons go, so you do not carry them far.
  • Learn how to fill a balloon with helium on two or three practice balloons first, then work at a steady pace.
  • Work with two people: one fills, one ties and adds ribbon.
  • Cut all the ribbon before you start.
  • Fill latex balloons on the day of the party. Read how long helium balloons last for timing.
  • Foil balloons smaller than about 18 inches are air-fill only and will not float.

Helium Tank Safety

  • Never inhale helium. Breathing it from a balloon or the tank can cause you to pass out. Keep kids away from the tank.
  • Keep it cool. Do not leave a tank in a hot car, near heaters or in direct sun for hours. Heat raises the pressure.
  • Keep it secure. Always strap the tank upright or lay it down so it cannot fall.
  • Use it in a ventilated space. Helium is not flammable, but it can push oxygen out of a small closed room.
  • Move it carefully. Close the valve and remove the regulator before you move the tank. Use a hand truck for large cylinders.
  • Do not tamper with the valve. If it leaks or will not close, stop and call the supplier.

When You Are Done

Close the main valve, empty the regulator by tilting the nozzle, and unscrew the regulator. Keep the empty tank upright and secure until pickup. If you rented from us, we pick up the tank at the end of the rental.

Helium Tank FAQ

How to open a helium tank if the valve is stiff?

Turn the handwheel counterclockwise with a firm, steady hand. Never use pliers or a wrench on the valve. If it still will not turn, stop and call us, since forcing it can damage the valve. This is one of the most important helium tank safety points.

How to fill a balloon with helium without popping it?

Tilt the nozzle gently and watch the shape. Stop when a latex balloon is round with a small neck. Use a balloon sizer box for even sizes.

Can kids help fill balloons?

Kids can tie ribbons and hand you balloons, but an adult should run the tank. Once you know how to use a helium tank, it takes about 20 to 30 seconds per balloon.

Rent a Helium Tank With the Regulator

Our helium tanks come in six sizes with the regulator, for a full 7 days and with no deposit. We deliver across New York, New Jersey, Connecticut and Pennsylvania and pick up the empty tank. See sizes and prices on the helium tank rental page, or let us fill the balloons for you with our balloon inflation service. Call (718) 787-4477 or send us a text.

For quick sharing this post click below
Facebook
X
LinkedIn
Reddit
Pinterest
Telegram
WhatsApp
Email
Print
Related Articles
Celebration EntertainmentOpen 7 days, 8AM to 8PM